28
Select the operation course to match the type of
clothes. (See page 25.)
• Each press switches the course as follows.
• The course can be switched even during operation. When
the course is switched during operation, drying operation
starts with the new course that you switched to after
cooling operation of two minutes maximum.
Information
•
blinks for approximately two minutes until the
estimated remaining time is displayed.
• If the
or
switch is pressed during operation,
the drum stops. If the equipment is left in this state for
approximately two minutes, drying operation is stopped,
and cool operation is started.
Information
3
Press
.
2
Press
and select the course.
Short beep
After about 5 to 10 seconds
Lights (green)
Lights (red)
Short beep
When drying operation ends, the buzzer sounds (three continuous beeps). Before
opening the front door, make sure that the operation/combustion lamp is off and
the SOFTEN&COOL lamp is blinking or on (green).
4
When the buzzer sounds, remove the clothes.
(3 beeps)
• Wait for the drum to come to a complete stop before removing clothes.
• Note that the lint filter and the area around the clothes removal port is hot immediately after operation ends.
Caution
• Cool operation begins after one minute if clothes are not taken out. Also, to lower the temperature inside the drum after removing clothes, close the front
door and resume cool operation after approximately two minutes. Operation automatically stops when cool operation ends.
• If drying operation is continued immediately after cooling operation, drying operation begins immediately after cooling operation of two minutes maximum.
• For details on how to stop cool operation, see pages 29.
Information
