57
Displayed Messages
常⻅故障
For displays marked by *,
the buzzer does not sound.
显 示
*
时，蜂鸣器不鸣叫。
Safety Interlock
安全装置
Function
功能
Cause
原因
Remedy
处理方法
Reference
Page
参照页
<blinks>
〈闪烁〉
Drum rotation sensor
(drum rotation abnormality)
干衣鼓旋转检测装置
（干衣鼓旋转异常）
Gas supply is stopped and cool operation is automatically
started when the drum does not rotate or drum rotation is
insufficient.
干衣鼓未旋转或转速不够时，关闭燃气，⾃动开始降温运行。
There is too much washing loaded in the equipment.
洗涤物品的量太多。
Reduce the amount of washing, and perform operation again. (as a guideline after
spin drying, within 9 kg)
请减少衣物后再次运行。（脱水后的参考值为 9 公斤以内）
30, 43
The electrical circuit of a motor, etc. is malfunctioning.
电机等的电气系统发生故障。
Repair is necessary. Contact the store of purchase or the Customer Support
Center.
需要修理。请与购买本产品的销售店或本公司顾客服务中⼼联系。
－
<blinks>
〈闪烁〉
Fan rotation sensor
(discharge fan rotation abnormality)
风扇旋转检测装置
（排湿风扇旋转异常）
Gas supply is stopped and cool operation is automatically
started when the discharge fan does not rotate, drum rotation
is insufficient or the drum rotates abnormally.
排湿风扇未旋转、转速不够或旋转异常时，关闭燃气，⾃动开始降
温运行。
Thin clothes with poor permeability or a mat is covering the lint
filter.
透气性差的薄衣物或垫子盖住了线屑过滤器。
Remove the clothes with poor permeability or the mat, then perform operation
again.
请将透气性差的衣物和垫子去掉后再次运行。
27, 28
The discharge tube is blocked.
排湿筒堵塞。
Repair is necessary. Contact the store of purchase or the Customer Support
Center.
需要修理。请与购买本产品的销售店或本公司顾客服务中⼼联系。
The electrical circuit of a motor, etc. is malfunctioning.
电机等的电气系统发生故障。
<blinks>
〈闪烁〉
Ignition/light out safety interlock
(ignition failure for 5 times continuous)
中途熄火安全装置
（连续5次点不着）
Gas supply is stopped and cool operation is automatically
started when lighting of the pilot light fails (continuously for 5
times) during ignition.
点火时，如果未点着（连续5次），则关闭燃气，⾃动开始降温运行。
This occurs, for example, when the gas cock is closed or was
not completely open.
在燃气阀被关闭或打开不充分时发生。
Wait approximately 2 minutes for cool operation (replacement with fresh air) to end
before inspecting and performing operation again.
请在约 2 分钟的降温（空气置换）运行结束后进行点检，然后再次运行。
25
<blinks>
〈闪烁〉
Error can be
canceled
错误能清除
Drum rotation sensor
(drum rotation abnormality)
干衣鼓旋转检测装置
（干衣鼓旋转异常）
Gas supply and operation are stopped when the drum does
not rotate or drum rotation is insufficient.
干衣鼓未旋转或转速不够时，关闭燃气并停止运行。
There is too much washing loaded in the equipment.
洗涤物品的量太多。
Reduce the amount of washing, and perform operation again. (as a guideline after
spin drying, within 9 kg)
请减少衣物后再次运行。（脱水后的参考值为 9 公斤以内）
30, 43
Error cannot be
canceled
错误无法清除
Fan rotation sensor
(discharge fan rotation abnormality)
风扇旋转检测装置
（排湿风扇旋转异常）
The electrical circuit of a motor, etc. is malfunctioning.
电机等的电气系统发生故障。
Repair is necessary. Contact the store of purchase or the Customer Support
Center.
需要修理。请与购买本产品的销售店或本公司顾客服务中⼼联系。
－
<blinks>
〈闪烁〉
Overheat prevention device
(thermocouple)
高温防止装置
（热电偶）
Gas supply is stopped and cool operation is automatically
started when lint blocks the lint filter or when the inside of the
equipment overheats abnormally.
线屑过滤器被布尘堵塞或机器内温度过高时，关闭燃气并⾃动
开始降温运行。
This occurs when there is insufficient air for combustion.
在用于燃烧的空气不足时发生。
Wait approximately 35 minutes for cool operation to end before inspecting and
performing operation again. (When there is too much washing loaded in the
equipment, remove the clothing or remove clothing with poor permeability, then
perform operation again.)
请在约35 分钟的降温运行结束后进行点检，然后再次运行。
（洗涤物品的量太多时，请
减少衣物，将透气性差的衣物去掉后再次运行。）
27, 28, 30,
47 to 50
27、28、30、
47至50
Lint has accumulated on the lint filter or the lint filter is blocked
with lint.
线屑过滤器上有布尘粘附，网孔被堵塞。
Thin clothing with poor permeability is covering the lint filter.
透气性差的薄衣物盖住了线屑过滤器。
There is too much washing loaded in the equipment.
洗涤物品的量太多。
This occurs when dust has built up inside of the equipment.
在机器内部有灰尘积聚时发生。
Repair is necessary. Contact the store of purchase or the Customer Support
Center.
需要修理。请与购买本产品的销售店或本公司顾客服务中⼼联系。
－
The discharge tube is blocked.
排湿筒堵塞。
<out>
*
〈灭灯〉
*
Overheat prevention device
(temperature fuse)
高温防止装置
（温度保险丝）
Gas supply, operation are stopped when the inside of the
equipment overheats abnormally.
机器内温度过高时，关闭燃气并停止运行。
This occurs when there is insufficient air for combustion.
在用于燃烧的空气不足时发生。
Repair is necessary. Contact the store of purchase or the Customer Support
Center.
需要修理。请与购买本产品的销售店或本公司顾客服务中⼼联系。
27, 28, 30,
47 to 50
27、28、30、
47至50
Lint has accumulated on the lint filter or the lint filter is blocked
with lint.
线屑过滤器上有布尘粘附，网孔被堵塞。
Thin clothing with poor permeability is covering the lint filter.
透气性差的薄衣物盖住了线屑过滤器。
There is too much washing loaded in the equipment.
洗涤物品的量太多。
The discharge tube is blocked.
排湿筒堵塞。
Repair is necessary. Contact the store of purchase or the Customer Support
Center.
需要修理。请与购买本产品的销售店或本公司顾客服务中⼼联系。
－
Overcurrent prevention device
(current fuse)
过电流防止装置（电流保险丝）
The current fuse and gas supply and operation are stopped
when an overcurrent flows.
过电流流过时，电流保险丝断开，关闭燃气并停止运行。
This occurs when an electrical circuit short-circuits.
电路短路时发生。
Display other than the above
显⽰上述以外的内容
Safety interlocks other than the above
上述以外的安全装置
A safe shutdown occurs when an abnormality other than
the above occurs.
发生上述以外的异常时进行安全停止。
Wait for the equipment to stop automatically before performing operation again. Repair is required when the safety interlock operates again.
Contact the store of purchase or the Customer Support Center.
请等到机器⾃动停止后再次运行。如果安全装置再次启动，则需要修理。请与购买本产品的销售店或本公司顾客服务中⼼联系。
－
Summary of Contents for RDT-42-CH-W
Page 63: ...62 中国RoHS法规标示要求 ...
Page 64: ...RDT62 0280 00 220326 ...
