Rievtech EXM-12DC-DA-R-HMI, User Manual, Page: 123 / 443

123
Software part:
Device IP factory setting
The default IP address of Ethernet module is
：
192.168.0.250
Network segment check of PC and Ethernet module’s
Users need ensure that PC has Ethernet cards,and that the network settings of PC and Ethernet module’s
must keep in the same network segment before establishing communication between PC and Ethernet
module.
The Ethernet module has a factory setting IP
（
192.168.0.250
）
and network mask
（
255.255.255.0
）
. Users
can process as shown in Figure 4.3 to check whether the Ethernet module and PC in the same network
segment. If in the same network segment, then congratulations to you, and you do not have to read the
following network setting contents. If it is different, then the following settings is very important to you.
Above contents is used to tell you how to make the user’s PC with the ethernet module in the same network
segment.
First part: set or modify IP address, port number with “DeviceManager2.00”