Calibration and operation
41
20093868
GB
Press
or
“info”
to return to standby mode.
The display shows
OPErAtE
.
When this screen appears you return to the normal display and you
can pass to the successive level mode.
Press
“i/reset”
to switch between the Service and
Parameter level.
Visualises the log of errors and some technical information regard-
ing the system.
The list of the parameters that can be visualised is given in the
table below.
To access this level, press the
“i/reset”
key for more than 3s.
Release the key immediately when the display shows
“SEr”
.
The list of the parameters that can be visualised is given in the table
below.
5.6
Service level
The Service level is used to display information about the errors in-
cluding the error chronology.
Note
:
From the Service level, it is possible to press
or
to display
the preceding or successive parameter.
Note
:
Instead of
it is also possible to press
“i/reset”
for <1 sec-
ond.
Note
:
It is possible to press
or
“i/reset”
for > 8 seconds for
normal display.
Note
:
No changes to the values of the Service level.
If the characters re displayed by the parameter, the value can be
composed of more than 5 figures.
Press
“i/reset”
for >1 s and <3 s to display the value.
ESC
S9061
P
V
h
min s
%
Fig. 70
S9063
/reset
Fig. 71
Service mode
S9103
/reset
P
V
h
min s
%
Fig. 72
Parameter
number
Parameter
700
Error history
701.00
Current error: Error code
701.01
Current error: Start-up meter reading
701.02
Current error: MMI phase
701.03
Current error: Power value
702.00
Error history former 1: Error code
702.01
Error history o1: Start-up meter reading
702.02
Error history o1: MMI phase
702.03
Error history o1: Power value
-
-
-
711.00
Error history former 10: Error code
711.01
Error history former 10: Start-up meter reading
711.02
Error history former 10: MMI phase
711.03
Error history former 10: Power value
900
Process data
920
Current PWM signal fan
936
Normalized speed
951
Mains voltage
954
Flame intensity
End
ESC
S906
4
Fig. 73
Parameter
Value
parameter
