Riden RD60 Series, Manual

Page: 21 / 77

21
CutOff temp.
➥
Battery Charger
OFF NOT monitoring external probe for Over Temperature while battery charging.
Value Set in
1°
steps
IF Set AND the temperature reaches, or exceeds, the set value:
● The output will immediately turn OFF.
● The
“
ON/OFF
”
button will turn off it’s illumination,
○ or react per the setting of ‘ External LED ’.
● Charge Status, on the display, will be set to "CHARGE: t°-OFF", indicating that
the charging cycle was halted due to temperature.
Notes:
- Disabled by setting to
0
.
- This setting is only applicable using the (Green) Battery Charging Binding post.
- Should be set to a higher value than the ambient temperature for proper operation.
- ‘CutOff temp’ setting is similar to the ‘ OTP (EXT) ’ setting, in that both serve the same
purpose of setting an upper temperature limit.
- However, ‘ OTP (EXT) ’ is a global feature,not limited to battery charging. final
safety measure, not specifically for battery charging.
IF ‘CutOff temp’ AND ‘ OTP (EXT) ’ are Enabled :
The value of ‘ OTP (EXT) ’ should be higher value than the ‘CutOff temp’
to ensure proper operation.
CutOff time
➥
Battery Charger
OFF NOT monitoring total time of charge while battery charging.
Settable Range:
00h 01m - 99h 59m
.
IF Set,
Battery charging cycle will halt once the set time is achieved.
Note:
This setting is only applicable using the (Green) Battery Charging Binding post.