Ricon Activan, Electrical And Pneumatic Circuit Diagrams Plus Diagnostic Flow Charts

Page: 8 / 44

5/10/99 SMA0001A.PDF 1-6
In-Floor Ramp Controller
11584
Connectors from Single Harness Controller to In-Floor Ramp Controller
J11-4 Pin
Connector DB9-9 Pin
Connector Wire
Color Function At Rest In Action
4 1 Green
2
3
4
2 5 Blue
1 6 Red
7
8
Single Harness Cont.
9
In-Floor Ramp Cont.
J10-10 Pin
Connector Amp 10
Pin
Connector Wire
Color Functions At Rest In Action
1- VCC 1 Red Power to In-Floor
Ramp Controller
12 Volts* 12 Volts
2- VCC 2 Red Power to In-Floor
Ramp Controller
12 Volts* 12 Volts
3- GND
3 Black Ground to In-Floor
Ramp Controller
Ground Ground
4- GND 4 Black Ground to In-Floor
Ramp Controller
Ground Ground
5- ROM 5 White Ramp Motor
Deploys; Tied with
other ROM wire
12 Volts Pulsed ground when motor
stows ramp (LED RO** will
light during action)
6- ROM
6 White Ramp Motor
Deploys; Tied with
other ROM wire
12 Volts Pulsed ground when motor
stows ramp (LED RO** will
light during action)
7- RCM 7 Purple Ramp Motor Stows;
Tied with other RCM
wire
12 Volts Pulsed ground when motor
stows ramp (LED RC** will
light during action
8- RCM
8 Purple Ramp Motor Stows;
Tied with other RCM
wire
12 Volts Pulsed ground when motor
stows ramp (LED RC** will
light during action
9-
DCLE
9 White Signals when ramp
is fully Stowed for
door operation
Fully Stowed:
Ground Partially Deployed: none
10- RSI
Single Harness Controller
10
In-Floor Ramp Controller
Red Ramp Stowed
Sensor Power
Supply
12 Volts to
Ramp
Stowed
Sensor 12 Volts to Ramp Stowed
Sensor
*If Supplemental Relay is disconnected, then the Single Harness Controller should have constant
12 volts power. This should supply the fuse at
F2 to supply the In-Floor Ramp Controller a
constant 12 volts on terminals VCC at J10 .
**These LED’s are located on the Single Harness Controller.