5/10/99 SMA0001A.PDF 1-4
In-Floor Ramp Controller 11584
-Installed to operate a Power In-Floor Ramp. The In-Floor
Ramp Controller is located under the access panel in the rear cargo area, next to the Single
Harness Controller. To access, pull aside flap of carpet, remove (4) Phillips screws, lift panel. In-
Floor Ramp Controller is a solid state device used to control the In-Floor Ramp motor. The In-
Floor Ramp Controller is interfaced to the Single Harness Controller. The In-Floor Ramp
Controller cannot be operated without being interfaced to the Single Harness Controller.
i
CAUTION
J10
AND
J11
ARE USED TO CONNECT THE IN-FLOOR CONTROLLER. THESE
TERMINALS WILL ONLY BE USED IN THE PRESENCE OF AN IN-FLOOR RAMP. DO NOT
CONNECT AN IN-FLOOR CONTROLLER, 11584, TO A SINGLE HARNESS CONTROLLER
WITH RELAYS INSTALLED ON SOCKETS
K2
AND
K3
. DO NOT INSTALL RELAYS INTO
SOCKETS
K2
AND
K3
IF THE SINGLE HARNESS CONTROLLER IS CONNECTED TO AN
IN-FLOOR RAMP CONTROLLER
i
CAUTION
TO AVOID DAMAGE TO THE STOW LOCK SOLENOID, DO NOT OPERATE RAMP MORE
THAN FIVE CYCLES (CONTINUOUSLY) WITHOUT PROVIDING AT LEAST A 1-MINUTE
COOL-DOWN PERIOD.
Access Panel in rear of vehicle, with carpet and cover removed.
Single Harness
Controller
In-Floor Ramp
Controller
