Ricoh Priport JP8000, Operating Instructions Manual

Page: 211 / 464

191
6. Remarks
Do's and Don'ts
R
CAUTION:
Important
❒
Make sure that
m
indicator on the PC controller operation panel is off before
unplugging the power cord.
• While printing, do not turn off the main switch.
• While printing, do not unplug the power cord.
• While printing, do not open the door or covers.
• While printing, do not move the machine.
• Open and close the door and covers softly.
• When printing onto paper that contains images on the back, make sure there
is a 10mm (0.4") margin at the back leading edge. If there is no margin, the ma-
chine might wrongly detect that paper is wrapped around the drum and stop
printing.
• When you use envelope or pasted print paper, the leading edge of print might
be damaged.
• Make sure to make a few trial prints to check the image position because the
image position of the trial print might not correspond with that of the origi-
nal.
• The leading edge of the prints might become stained if the edge touches the
image of prints on the paper delivery tray.
• Print ink on the paper delivery tray might stick to the back side of the next
print.
• Press the
{
Proof
}
key to perform a test print as the image density of the first
few prints might be light.
• When the machine is on and the power source is less than 90% of the specified
amount, printing quality will decrease. Therefore, make sure the supply from
your electrical outlet is at least 90% of the required amount.
• When you make a lot of prints from a small image, ink might ooze out from
the edges of the master, especially under high temperature and when print-
ing in two or more colors. In this case, make a new master.
• Remove the paper from the tray before relocating the machine. If you relocate
the machine leaving the paper on the tray, reset the paper after the relocation.
If the main switch of the machine is turned on without resetting the paper cor-
rectly, the sensor might be broken.
• Unplug the power cord from the wall outlet before you move the equipment.
While moving the equipment, you should take care that the power cord will
not be damaged under the equipment.