Technical Bulletin
No. RTB-003
SUBJECT: LCT Side to Side Registration Adjustment
DATE: Feb. 15, ’91
PAGE: 1 of 2
PREPARED BY: M. Ninomiya
CHECKED BY:
FROM: Copier Technical Support Sec.
CLASSIFICATION:
Action Required
Troubleshooting
Retrofit Information
Revision of service manual
Information only
Other
MODEL: F-40
Specification
Side registration: 0
±
2.0 mm
Preparation (Making a test sheet)
1. Fold an A4 (8 1/2 x 11) sheet exactly in half. Then draw a 2.5 cm (1 inch) line [A] on the
crease from an edge of the sheet.
Confirmation
1. Make a copy of the test sheet in platen mode from the LCT.
2. Fold the copy once with the fold running down the middle of the copy, then verify that
the vertical line at the top center of the test chart is on the fold or within 2.0 mm of the
fold.
3. If the side registration of the LCT is not within the specifications, follow the procedure
below:
2.5 cm
[A]
REVISED ON MAY 15
[B]
[B]
[B]
[B]
