Technical Bulletin
No. RTB-011
SUBJECT: Original side to side registration
DATE: 15 Aug. ’91
PAGE: 3 of 5
•
Reinstall the springs for the release lever
unit as in figure 5.
•
When reinstalling the original stopper
solenoid, make sure that the harness is
out of the way [A] and that you place the
bracket in the socket [B] as shown in
figure 6.
•
Check to see if the release lever and the
original stopper unit work properly.
•
Make sure the three original stoppers are
parallel and that the stoppers do not
touch the original table unit. The
specifications are shown in figure 7.
•
Test run the machine before
reassembling the front and rear covers.
Fig. 5
Fig. 6
[A]
[B]
1
±
0.2 mm
Fig. 7
