Technical Bulletin
No. RTB-011
SUBJECT: Original side to side registration
DATE: 15 Aug. ’91
PAGE: 2 of 5
8. Remove the original table with the side
fences (7 screws) as in figure 3.
Make sure that the feed-out unit is placed
at the right end [A].
Be careful not to damage the exit roller
paper guard [B].
9. Remove all the parts from the original
table.
10. Place the side fence in the middle of the
new original table [C], and assemble the
new table unit as shown in figure 4. The
parts marked [*] are new parts. Refer to
Modification Bulletin (F40 - No. 11)
11. Reinstall the unit.
NOTE:
When reinstalling the unit, make
sure of the following.
•
Set the new original table following the
sequence in figure 3, but in reverse.
[B]
[A]
Fig. 3
[C]
Fig. 4
[*]
[*]
[*]
[*]
[*]
