SERVICE CALL CONDITIONS
B234/B235/B236/D101/D102/D103
4-60
SM
Rotate HP Sensor 1 (S95) Error
SC795-27
A
Rotate motor 1 (M42) did not leave the
home position and the HP sensor did not
go OFF after enough time elapsed for
rotation through an arc of 50°.
-or-
The motor did not arrive at the HP
sensor. When rotate motor 1 (M42),
rotate motor 2 (M41) were both
initialized, their HP sensors did not turn
ON after enough time elapsed for
rotation through an arc of 440°.
•
Jam or overload during book
rotation.
•
Rotate motor 1 (M42)
connections loose, broken,
defective
•
Motor defective
•
Rotate HP sensor 1
(S95)harness loose, broken,
defective
•
Rotate HP sensor (S95)
defective
Rotate HP Sensor 2 (S91)
SC795-28
A
Rotate motor 2 (M41) did not
leave the home position and the
HP sensor did not go OFF after
enough time has elapsed for
rotation through an arc of 30°.
-or-
Rotate motor 2 (M41) did not
reach the home position and the
HP sensor did not go ON after
enough time had elapsed for
rotation through an arc of 400°.
•
Jam or overload during book
rotation.
•
Rotate motor 2 (M41) connections
loose, broken, defective
•
Motor defective
•
Rotate HP sensor (S91) harness
loose, broken, defective
•
Sensor defective
Cutter Motor (M35) Error
SC795-29
A
One of the following occurred:
•
The cutter blade did not move after it
was moved to the rear (it did not leave
home position).
•
The blade did not move away from the
cutting point on the blade cradle (it did
not arrive at the home position).
•
The blade did not move for a rear-to-
front cut.
•
The blade did not move away from the
blade cradle to the front within 10 sec.
•
When moving from the front the blade
did not reach the blade cradle within 10
sec.
•
When moving from the rear, the blade
did not reach the blade cradle.
•
Cutter motor (M35)
connections loose, broken,
defective
•
Motor defective
•
Blade sensor 1, 2 (S84,
S85) sensor harness loose,
broken, defective
•
Sensor defective
•
Blade is dull, cutting poorly
•
Note: Sensors S84, S85 are
on the cutter area PCB.
Trimmer Limit Sensor (S86) Error
SC795-30
A
The blade reached the limit
position and the trimmer limit
sensor went ON.
•
Cutter motor (M35) connections
loose, broken, defective
•
Motor defective
•
Trimmer limit sensor (S86) harness
loose, broken, defective
•
Sensor defective
•
Plate out of position (see below
Note
: For a detailed description about how to correct this problem, please
refer to the replacement and adjustment procedures in the Perfect Binder
manual under "Trimming Unit" in the "Common Procedures" section.
