Ricoh 400672, Operating Instructions Manual

Page: 42 / 60

Sending Originals
32
3
Setting the Original on the
Platen Glass
A
Lift the ADF.
Note
❒
Raise the ADF fully (more than
30 degrees). The opening/clos-
ing action triggers the automatic
original size detection process.
B
Place the original on the platen
glass with the side to be scanned
facing down. Align the far left
edge of the original with the mark.
For information about original ori-
entation, see P.29
“Original Setting” .
A Original width is within 297
mm (11.7").
B Original width is wider than
297 mm (11.7").
When set with this direction,
the original orientation setting
for delivery must be changed.
⇒
P.36 “Sending Scans”
C
Lower the ADF.
Setting Originals in the ADF
A
Adjust the side guides to the size
of your originals.
B
Place your originals face up
(when performing duplex scans,
front page up), and align them.
For information about original ori-
entation, see P.29
“Original Set-
ting” .
Note
❒
If the scan width is the same,
you can set originals that differ-
ent length.
❒
The originals are scanned in se-
quence, starting with the top
page.
A Setting an original less than 297
mm (11.7") wide:
Setting position
TNSY021J
Setting position
TNSY023J
ZEPY010J