Ricoh 400672, Operating Instructions Manual

Page: 31 / 60

Scan Setup
21
2
B
Using the reference start point as
the origin, enter the horizontal
and vertical distances from the or-
igin of the area you wish to scan.
Next, enter the size of the area.
Then, press
{{{{
#
}}}}
.
This is an example when using
millimeters.
Press
{
#
}
to move the cursor to the
next field. You can also move the
cursor by pressing
0
or
1
.
The following illustration shows
how to make your adjustments us-
ing the reference start point of the
scanner.
A When originals are set on the
platen glass:
In this situation, you can scan
monochrome and color origi-
nals up to 300 mm (11.8") verti-
c a l l y a n d 4 3 2 m m ( 1 7 " )
horizontally from the origin.
Make adjustments so that the
area you wish to scan does not
fall outside this perimeter.
B When originals are set in the
Auto Document Feeder (ADF):
In this situation, you can scan
monochrome and color originals
up to 297 mm (11.7") vertically
from the origin. Horizontally, you
can scan monochrome originals up
to 2000 mm (78.74") from the ori-
gin, and color originals up to 630
mm (24.8") from the origin. Make
adjustments so that the area you
wish to scan does not fall outside
this perimeter.
Note
❒
The reference start point of the
ADF is located on the inside of
the fully extended paper guide
on the operation panel side of
the scanner.
❒
When performing duplex scans,
you can scan monochrome and
color originals up to 297 mm
(11.7") vertically and 432 mm
(17") horizontally from the ori-
gin.
Start point,
horizontal
Scan area
Start point,
vertical
Scan area,
vertical
Scan area,
horizontal
Positioning
mark
TNSY090E
ZEPY030E