Richmond GTR062, User Manual

Page: 16 / 21

19
How to use the remote to operate your gate opener
Each remote has four buttons, from top to bottom are separately A, B, C and D.
You may use this remote to operate as many as 4 sets our swing gate
opener or 1 set our sliding gate opener and 2 sets our swing gate opener.
1. Use this remote to only operate our swing gate opener
A,B,C and D four buttons share same function once they are programmed with
our swing gate opener. You may choose any button to program it with our swing
gate opener. Every press of the button is able to active the gate opener to work
alternately (open-stop-close-stop-open).
2. Use one remote to operate our swing gate opener & sliding gate opener at the same time
All of our sliding gate opener have midway mode. B is designed to realize midway function (refer to more details
in our sliding gate opener manual). So it is must program A button with sliding gate opener, while you may
program either C button or D button with our swing gate opener.
Wireless keypad programming
You can follow the below steps to program wireless keypad to the opener. Press the CODE SW button until the
CODE LED is ON , and then release the button. Then press "OK" button on keypad and CODE LED will flash for
3 seconds and then be OFF which indicates the keypad has been programmed successfully. You can use the
default password “888888” to operate the opener after programming. You can press
“PIN” “8 8 8 8 8 8” and
then press “OK” to confirm to operate the opener.
Also you can change the password of the keypad follow the below steps. Press “PIN” and then input the six
digits old password and then press ”PIN” again, the
CODE LED will be ON. Input the six digits new password
and then press the “PIN” to confirm the new setting, CODE LED will flash for 3 seconds and then be OFF which
indicates the password has been changed successfully. You can press “PIN” “6 digits new password” and then
press “OK” to confirm to operate the opener.
NOTE: Every step for pressing button during program must be finished within 1 second to ensure successful
programming.
Setting of the Control Board
WARNING: Ensure the gate opener is Power Off when you make any adjustment of the gate opener.
Keep away from the gate during you set the gate opener system in case of the unexpected gate moving.
Carefully adjust the DIP switches to avoid the risk of machine damage and injury or death. Always ask
the help of professional technician /electrician if you have any question.