Configuration
© Rice Lake Weighing Systems
●
All Rights Reserved
29
4.4.4.3 Ethernet Menu
Figure 4-11. Communication – Ethernet Menu
Parameter
Description
mac id
Mac ID – Read only;
Settings: 00:00:00:00:00:00
dhcp
DHCP – Dynamic Host Configuration Protocol (static allocation of IP address when OFF);
Settings:
ON
(default), OFF
enable
Enable – Enables Ethernet communications;
Settings:
OFF
(default), ON
ipaddr
IP Address;
Enter value: 0.0.0.0
subnet
Subnet Mask;
Enter value: 255.255.255.0
gatewy
Default Gateway;
Enter value: 0.0.0.0
server
Ethernet Server – Allows the 680HE to receive external EDP commands;
Sub-parameters:
PORT – Specifies IP Address port to open to establish communications;
Enter value: 1025–65535,
10001
(default)
NAME – Name for Ethernet Server;
Enter characters: Alphanumeric entry up to 8 characters,
0
(default)
INPUT – Sets the input trigger type;
Settings:
CMD
(default), NONE
ECHO – Specifies if characters received by the port are echoed back to the sending unit;
Settings:
OFF
(default), ON
TERMIN – Line Termination: Sets the termination character for data sent from the port;
Settings:
CR/LF
(default), CR
RESPNS – Specifies if the port transmits replies to serial commands;
Settings:
ON
(default), OFF
client
Ethernet Client – Allows the 680HE to send EDP commands to external devices;
Sub-parameters:
ECHO – Specifies if characters received by the port are echoed back to the sending unit;
Settings:
ON
(default), OFF
EOLDLY – End of Line Delay: Sets the delay period from when a formatted line is terminated to the beginning of the
next formatted serial output (measured in milliseconds);
Enter value: 0–255,
0
(default)
IPADDR – IP Address;
Enter value: 0.0.0.0
TERMIN – Line Termination: Sets the termination character for data sent from the port;
Settings:
CR/LF
(default), CR
PORT – Specifies IP Address port to look for to establish communications;
Enter value: 1025–65535,
10001
(default)
RESPNS – Specifies if the port transmits replies to serial commands;
Settings:
ON
(default), OFF
INPUT – Sets the input trigger type;
Settings:
CMD
(default), STRIND, STRLFT, REMOTE
DSCTIM – Disconnect Timeout (in seconds);
Enter value: 0–60,
0
(default)
Table 4-10. Communication – Ethernet Menu Parameters
Setup
Comm
ETHNET
DHCP
enable
IPADDR
subnet
gatewy
SeRVeR
port
name
input
ECHO
TERMin
ReSPNS
CLieNT
ECHO
EOLDLY
IPADDR
TERMin
port
respns
input
dsctim
mac id
Summary of Contents for Synergy 680HE
Page 77: ......
