RHINO Turbo 120, Operator'S Manual

Page: 103 / 222

ASSEMBLY
TURBO 120 08/12 Assembly Section 3-5
© 2012 Alamo Group Inc.
ASSEMBL
Y
CONTROL RODS
Attach the two level-lift control rods to the lower lugs on tongue and to lugs on the rear axle tube using pins,
washers and cotter pins.
Note: The adjusting nuts on control rods should be to rear of machine and should
always be adjusted with equal tension on both rods. Figure Asm-R-0289 & Asm-R-0290
DRIVELINE CLAMP CONE YOKE
Loosen the yoke clamp cone with a 11/16” (17mm)
wrench and remove the cone from yoke. Slide yoke
onto the shaft and align hole for clamping cone with
annular groove of gearbox shaft. Reinstall cone and
tighten (75 lb.-ft. torque). Push and pull the driveline
to ensure it is securely attached to the shaft.
Regularly check the driveline yoke to ensure a tight
connection. To remove the yoke, remove the
connecting cone and pull yoke off the shaft. If the
cone cannot be easily removed by hand, drive it out
from the other side using a hammer and punch.
NOTE: The clamping cone is serviced only as a complete assembly. Do not attempt to disassemble the
clamping cone.