RHINO RD160 E3, Operator'S Manual

Page: 68 / 85

68
Rhino RD160 E3/E4
MAINTENANCE
BROOMS
Main Broom
Ÿ
The main broom used in the machine is of a cylindrical type and spans the
width of the machine.
Ÿ
The main broom sweeps the debris into the hopper.
Ÿ
Check the main broom everyday for wear or damage.
Ÿ
Remove any wires, ropes or strings from the main broom to avoid damage
to the main broom, drive hub or other drive components.
Ÿ
Adjust the main broom pressure by using the knob on the operators cab.
Ÿ
Replace the broom if worn out/damaged or it no longer sweeps
effectively.
1. Park the machine on a flat surface.
2. Engage parking brake.
3. Raise the main broom.
4. Stop the engine.
5. Remove key.
6. Open the left side door of the broom compartment.
To replace the main broom:
7. Remove the idler hub by operating the toggle clamp. (Pull the toggle
clamp towards the user).
8. Grasp the main broom and pull it outward. Wear safety gloves when
handling the main broom.
Toggle clamp
Idler hub
9. Place the new broom or the existing rotated end-to-end broom on the
floor near the broom chamber access door.
10. Slide the main broom into its chamber till it engages on to the drive hub.
11. Now slide the idle side hub back in its position and secure it with the
toggle clamp.
12. Close the broom chamber door.
Forward