RHINO RD160 E3, Operator'S Manual

Page: 29 / 85

29
Rhino RD160 E3/E4
INITIAL SET-UP
UNLOADING
To unload the machine follow the procedure as follows:
è
Position the transport truck near a ramp.
è
Remove the protective cover.
è
Remove the strap belts and chains that secure the machine.
è
Remove the wheel blocks.
è
Drive to unload the machine from the pallet (if equipped).
CAUTION: Owner’s personnel are not allowed to unpack the
machine.
WARNING: The ramp’s minimum load bearing capacity should be
three tonnes. Risk of damage, Risk of injury.
l
Do not use a forklift.
l
Observe carefully when loading in a ramp: Ground
clearance should be 70 mm.
l
Risk/Danger of tipping over if gradient is too high.
l
Do not unload the machine on an inclined ramp or
platform.
l
Do not unload the machine on wet areas.
l
Use appropriate tools and safety devices.
Safety chain
Wheel block
Pallet (if equipped)
Upon Unloading
l
Check the machine for any transit damage such as dents,
paint damage, scratches, leaks, etc.
l
Check coolant level in the radiator.
l
Check the engine oil level.
l
Check the hydraulic oil level.
l
Check the Main and Side Broom for damage.
l
Connect the battery leads.
l
Remove the eye bolts and store them in the machine for future use, also
remove the eye bolt sticker and dispose it off after commissioning the
machine.
l
Check the machine’s invoice against the machine for the required
accessories and serial number.
If the coolant, oil, fuel levels are low top them up with the recommended
grades.
WARNING:
è
Do not smoke while refueling or topping up fluids.
è
Do not refuel or top up near open flames/fire.
è
Do not refuel or top up near a hot surface.
WARNING:
è
Do not let fuel or oil to leak into the environment.
USE ONLY DIESEL FUEL.
DO NOT ADD ANY ADDITIVES.