DSPbR EDGE
Series User’s Manual
Asia Pacific | EMEA | Americas
9
6. Occupational Health & Safety / Work Safe and Safety Warnings
Only a suitably qualified person should be allowed to install and commission this equipment after
becoming familiar with all the safety and installation i
nstructions contained in this User’s Manual. It
will be assumed that a qualified person will have a fundamental knowledge of the
installation’s
objectives and use common sense where safety warnings are not necessarily explicit.
The unit is heavy and appropriately considered a two-man lift. Handles are provided to the front of the equipment to assist in
removal of the DSPbR® from the packaging and during installation.
On unpacking the equipment, familiarise yourself with equipment, reading and following all warning labels attached to the
equipment. Please ensure that the warning labels are kept in a legible condition and replace if necessary.
Ensure all general, regional and site-specific installation and safety regulations are adhered to when working on high voltage
installations, as well as regulations covering use of tools and personal protective equipment.
It is the responsibility of the network operator or service provider to have in place and implemented compliant Occupational
Health and Safety (OHS) / Work Health and Safety (WHS) procedures as applicable, detailing prevention measures to avoid
health hazards which may be associated with radiation from the antenna(s) connected to this equipment. Please ensure
familiarisation and compliance to country specific regulations on RF exposure.
Ensure all adjustable repeater settings comply with intended use and applicable National, State and Regional regulatory
requirements.
Ensure that access to this equipment is restricted to qualified personnel only.
There is no On/Off switch on the DSPbR EDGE unit. The unit becomes active and commences its start-up routine as soon as
power is connected via the provided power cable.
Do not allow the DSPbR EDGE or any associated equipment to become wet or to be subjected to a corrosive environment,
humidity or temperatures outside the specified operating ranges.
Do not operate the unit near any flammable substances or in a flammable atmosphere.
Ensure that all RF termination connectors are fully mated and tightened using correct torque values.
Should an upgrade or maintenance require any further deconstruction or access to the equipment, the AC or DC power supply
should be disconnected and isolated.
NOTE:
For AS/NZS60950 compliance the DSPbR Edge shall be powered using an
Australian approved supply cord and plug.
The mains power socket outlet shall be installed near the equipment and shall be easily
accessible.
