DSPbR EDGE
Series User’s Manual
Asia Pacific | EMEA | Americas
39
10.18 Configuration
– Duplexer
DUPLEXER CONFIGURATION
The unit’s Duplexer tuned frequency passbands and insertion loss values can be entered on this page.
Duplexer Settings (‘Donor’ side and 'Service’ sides)
Downlink In:
The Donor and Service side duplexer passband frequencies (in MHz) in the downlink (donor-to-service) path. A lower end (Freq
Min) and upper end (Freq Max) value is required.
Uplink Out:
The Donor and Service side duplexer passband frequencies (in MHz) in the uplink (service-to-donor) path. A lower end (Freq Min)
and upper end (Freq Max) value is required.
Insertion Loss:
The insertion loss values here are used within the EDGE to calculate unit Tx output power values. The insertion loss value should
be the average insertion loss of the passband across its nominated frequency range.
Note:
This information is also used to populate the Duplexer section of the
Status/Hardware
GUI page.
The contents of the page are described in the Help screen.
