Reznor VS15LHE8, Installation & Operating Manual

Page: 58 / 60

11. User & operating instructions
To Start the Heater
1. Ensure gas supply is turned on.
2. Electrical supply to the controls is on.
3. Ensure that the controls are correctly set
i.e.; Clock is correctly set. Heater program
is correctly set. Required room temp is
correctly set
4. Once the heating controller ‘calls for heat’
power will be supplied to the heater(s).
The red neon will then illuminate.
5. After a pre-purge period of 10 seconds the
burner will ignite and the amber neon will
then illuminate.
6. If lockout occurs press the lockout
reset button (if available), or switch off
electrical supply and restart after 15
seconds.
7. If lockout occurs three times
consecutively switch off and isolate the
gas and electricity supplies.
Contact your local representative
To Switch Off Heater
1. Switch off electrical supply to the heater.
The burner will stop and the fan will shut
off.
2. If the heater is to be switched off for
periods in excess of one week it is highly
recommended that both the gas and the
electrical supplies are turned off.
Routine Maintenance between Service Intervals
After ensuring that the heater is cold and
mains electric isolated, cleaning of the
reflectors with a soft cloth and a mild deter-
gent (non solvent based cleaners only) in
water can be undertaken.
Additional removal of dust from the radiant
tubes, and burner can be undertaken.
Frequency of Servicing
The manufacturer recommends that to
ensure continued efficient and safe opera-
tion of the appliance, the heater is serviced
annually by a competent person e.g. every
year in normal working conditions but in
exceptional dusty or polluted conditions
more frequent servicing may be required.
The manufacturer offers a maintenance
service. Details are available on request.
For service requirements, please contact
your local representative
For further technical and service support
visit our Support Information Database at
www.s-i-d.co.uk
58