Reznor VS15LHE8, Installation & Operating Manual

Page: 32 / 60

30–50kW models
require pins to engage
with hole in tube and
damper
Emitter Tube
15–25kW models do not
have locating pins in tube
coupler
Socket heads facing
upwards
Flow
Flow
(Rotated View)
2.2.11.4 Herringbone Damper Assembly
Locate and position tube coupler onto the
outlet end of the tube so that the socket
heads are facing upwards towards the
welded seam. Make sure the pre-fitted bolt
in the coupler engages with the 13mm
locating hole in the tube (not 15-25kW
models). Slide the herringbone damper
assembly into the open end of the coupler
and ensure the 13mm locating hole in the
damper engages with the pre-fitted bolt in
the coupler (not 15-25kW models).
The damper assembly must be positioned
so that the test nipple is on the top. Tighten
socket head clamping bolts, alternating
between bolts until fully secure.
The damper assembly must be located with
its damper blade in the closed position.
CAUTION
Do not apply sealant!
Vacuum Test Nipple
Flow
Flow
Manifold Tube
Damper Blade Handle
Figure 39. Herringbone damper assembly
Figure 39.1 Herringbone damper assembly
32