Reznor VS15LHE8, Installation & Operating Manual

Page: 53 / 60

STEP 2
Open the left hand access door and detach the
impulse hoses from the air pressure switch.
STEP 3
Remove the four screws holding the burner
head onto the burner assembly.
The burner head can now be detached by
disconnecting the impulse tube and the burner
head wiring.
STEP 4
Detach the two screws holding the front of
the gas valve.
STEP 5
Remove the four screws holding the rear burner
plate in position. Remove the rear plate.
The jet carrier, gas inlet, and harness can
now be detached from the gas valve.
STEP 6
The two screws retaining the gas valve can
then be removed.
STEP 7
The gas valve can now be replaced.
Ensure the correct type of gas valve is used,
see Section 5.1 for more details.
Refit all components in reverse order.
Set gas pressures to data badge or as per
section 1.12 on page 21 and ensure reli-
able burner performance.
Test product and close access doors.
STEP 2
Remove the two screws attaching the control-
ler to the burner and remove.
Disconnect HT Lead from burner controller.
7.3 SIT Sigma gas valve replacement
STEP 1
Remove the burner assembly as described in
section 4.3 Servicing. Open the right hand
access door and detach the burner controller
from the wiring harness.
7.4 Burner controller replacement
(Honeywell VK valves)
STEP 1
Slacken screw in burner lid and open the right
hand burner access door.
Disconnect wiring harness from the burner
controller.
53