![background image](http://html1.mh-extra.com/html/rexroth-indramat/mannesmann-dkc21-3/mannesmann-dkc21-3_application_1449638017.webp)
Application
Standard Roll Feed
2-11
DOK-SUPPL*-BTV04*ELW**-AW01-EN-P
In single step set-up mode a new start signal must come after every step.
If “operating mode select” F2 for automatic mode has been selected, then
the following appears:
Operating mode selection
F1 = feed leads / single
F2 = feed leads / continuous
F3 = press leads / single
F4 = press leads / continuous
Using keys F1 to F4 it is now possible to select various operating mode
combinations (feed leads, press leads, press single hub and press con-
tinuous run). After actuating the relevant key, the required program is
transmitted into the ELC and a message that states that the transmission
is completed comes after about five seconds.
Note:
For the transmitted programs to work in set-up and automatic
modes and for the operating mode display to be correct on the
BTV, task3 of the ELC in block number 0035 must be re-
leased.
Parameter AA00 = XXXX 0035 X
F2 Current operating mode
If „Operating mode“ has been selected with F2, then the currently pro-
grammed operating mode selected appears, as is shown below:
Current operating mode
automatic mode
press single hub
feed leads
Note:
To correctly display the operating mode, markers 40 to 46 are
processed in task3. The commands for this are automatically
sent with the operating mode.
Summary of Contents for Mannesmann DKC21.3
