GB-47
ENGLISH
Care/Maintenance
Care/Maintenance
We recommend checking all machine parts that could loosen
(screws, nuts, etc.) regularly every 2 to 4 weeks, depending
on the frequency of use. Use a soft, perhaps slightly moiste-
ned cloth to clean. Do not use aggressive cleaning agents.
Keep liquids of any type away from the computer and the
machine interior, as the liquids could cause considerable
functional impairments. The belt in the lower area of the
exercise machine can develop rubber skid marks. This is
completely normal.
Treadmill adjustment
After a longer period of use or after transport, the walking
belt may no longer be centred or may “slip away ” during
your workout. In this case you will have to readjust the
walking belt, as damage and functional impairments could
occur.
Centring the walking belt:
You can adjust the walking belt with an M6 Allen key at the
right rear end of the main frame (see Fig.).
If the walking belt has slipped over to the right, turn the
right adjusting screw clockwise (no more than a 1/4 revolu-
tion).Then let the treadmill run for at least 2 revolutions to
check if the adjustment is suffi cient. Repeat this procedure
until the belt is centred.
If the walking belt has slipped over to the left, turn the
right adjusting screw anti-clockwise (no more than a 1/4
revolution). Then let the treadmill run for at least 2 revolu-
tions to check if the adjustment is suffi cient. Repeat this
procedure until the belt is centred.
Tensioning the walking belt:
You can tension the walking belt with the two adjusting
screws at the right rear end of the main frame (see Fig.).
Turn the left and right adjusting screws evenly a quarter
turn to the right (clockwise). Use an M6 Allen key for this.
Then switch on the treadmill and check if it is suffi ciently
tensioned.
Repeat the procedure until the walking belt stops “slipping
away” during running. However, never turn the adjusting
screws more than a quarter turn after each check. If the
walking belt is adjusted too tightly, evenly loosen both ad-
justing screws.
You must disconnect the mains plug from the power
outlet before any care and maintenance work! MORTAL
DANGER!
DANGER
Make sure the treadmill is not in operation during the
adjustment. Remove the safety key to ensure your safety.
WARNING
➡
➡
Make sure not to tension the walking belt too strongly
as this results in increased wear or even damage.
WARNING
REX_Trainer_TX800_12.indd GB-47
REX_Trainer_TX800_12.indd GB-47
22.05.12 15:33
22.05.12 15:33
