Revell Control 24067, Manual

Page: 10 / 68

10
Safety Tips resolution of errors
cause:
• The ON/OFF switch is set to “OFF”.
• The battery is too low or empty.
• The helicopter is not ready.
remedy:
• Set the ON/OFF switch to “ON”.
• Charge the battery.
• Set the actuating regulator to full and back to
zero and wait for 5 seconds.
Problem:
The rotor blades do not move.
cause:
• The battery is too low.
• The infrared connection is being disturbed
(e.g. excessively bright lighting).
remedy:
• Charge the battery.
• Secure the infrared connection; change the
location if necessary.
Problem:
The helicopter stops for no clear
reason during flight and drops.
cause:
• Another infrared source is disturbing the
signal transmission.
• The signal transmission is disturbed due to
bright light irradiation.
remedy:
• Avoid possible infrared disturbance sources
or switch them off.
• Use the helicopter in a different location.
Problem:
The helicopter cannot be
controlled.
cause:
• Trimming too extreme to the right or left,
e.g. due to incorrect, permanent pressing on
the trim buttons
remedy:
• Reset the trimming by repeated, brief taps
on the trim buttons for the opposite direction
(see Page 8)
Problem:
The helicopter only pivots on its
own axis to the left or right.
Service guidelines
At www.revell-control.de, you can find our possibilities to order,
replacement tips for spare parts, and further useful information
on all revell control models.
www.revell-control.de
You can find further tips and tricks on the Internet at www.revell-control.de.
English
24067_RC_Anl_Moovee_08.indd 10 16.12.11 14:31