Owners Manual
INTRODUCTION
Congratulations on your purchase of a Renkus-Heinz Iconyx Steerable Column Loudspeaker. We hope you
enjoy it.
Your Iconyx Steerable Column Loudspeaker was carefully tested and inspected before leaving our factory
and should have arrived in perfect condition. Please carefully inspect the shipping carton(s) and loudspeak-
er(s) for any noticeable damage, and if any damage is found, immediately notify the shipping company.
Only you, the consignee, may institute a claim with the carrier for any damage incurred during shipping. Be
sure to save the carton(s) and all packing material for the carrier’s inspection.
It is also a good idea to save the carton and packing material even though the loudspeaker arrived in good
condition. If you should ever need to ship the loudspeaker, it should be shipped in its original factory packag-
ing.
GENERAL INFORMATION
To simplify shipping and handling, ICONYX arrays are constructed from 8-channel or 16-channel modules
and need to be assembled in the field. The assembly hardware is packed with the modules in cardboard
box(es) that double as carton “fillers”. The ones containing the hardware are marked “Hardware” to prevent
their being accidently discarded.
If you purchased an
IC8
or
IC16/8
, all you need to do is remove the column loudspeaker and its hardware
box from the carton and install it. Skip to page 9 for Address Number Verification instructions.
If you purchased an
IC16
or an
IC32/16
, you should have received two cartons (two 8-channel or 2-16 chan-
nel modules) and will need to assemble them into a 16- or 32-channel unit. Each carton will include a hard-
ware box, but if you purchased an IC16 only the box in carton 1 will include hardware; the box in carton 2
will be empty. If you purchased an IC32/16, both boxes will include hardware.
If you purchased an
IC24
, you should have received 3 cartons (three 8-channel modules). The hardware
boxes in cartons 1 and 2 will include hardware, while the box in carton 3 will be empty.
If you purchased an
IC32
, you should have received 4 cartons (four 8-channel modules) and will need to
assemble them. The hardware boxes in cartons 1, 2 and 3 will include hardware; the box in carton 4 will be
empty.
A detailed listing of the hardware supplied with each model follows on the next page. The cartons will be
marked to show the modules’ position in the finished column array; for example, top, bottom, center, etc.
In all cases, if you ordered a mounting hinge kit with the loudspeaker the female portions of the hinge
assemblies will have been installed on the modules for you. The male portions of the wall mounting hinge
assemblies will be packed in the hardware box(es). A dimensional drawing of the column array and paper
mounting templates were included in the plastic bag that contained this manual.
Note that the male sections have been set up to allow the column to swing to the right away from the wall. If
you want the column to swing to the left, you will need to change the location of the hinges from the right
side of the wall mounting plate to the left side. Refer to the Installation section of this manual for more infor-
mation.
Owners Manual
4
