
9
unattended, in order to minimize the risk of injury caused by a
fall.
▪
A handset must be locked if the patient should not change the
height and/or tilt of the back and/or leg sections, or when there
are doubts
concerning the patient’s ability to safety control the
functions of the bed.
▪
In the absence of supervision of the patient (if such
circumstances occur), the bed should be set to the highest
position of railings on both sides of the bed. Unlocking and
lowering them can be done only by the person responsible
(care person or nurse).
▪
The patient should not be left in the Trendelenburg or reverse
Trendelenburg position!
▪
The bed is not intended for patient’s transportation. The
manufacturer allows moving the bed with patient within the
room to clean or gain access to the patient. In such a case,
special attention should be paid to disconnect the bed from the
power supply before transporting the bed. The transportation
should take place in the lowest position of the mattress
platform while maintaining the patient in the horizontal lying
position.
▪
Side rails must be installed on both sides of the bed (on the side
of the wall as well).
▪
Standard height side rails enable to use mattresses with a
maximum height of 150 mm.
▪
Side rails may only be used with proper size mattresses
intended for the bed
–
otherwise there is a risk of the user
entrapment.
▪
Leaning against or resting on rails may cause accidents!
▪
Leaning out of the bed is a threat of injury!
▪
In case of damage to the rails (bending, breaking, cracking etc.),
they should be immediately replaced with new ones due to the
risk of an accident.
▪
Placing limbs between the moving elements of the bed may
cause injury and accidents.
▪
Do not exceed the safe working load of the bed!
▪
Maximum operating time of actuators is
2 minutes for 18
minutes break
. Failure to comply with the afore-mentioned
will result in permanent damage to the actuator.
▪
During the adjustment and maintenance attention should be
paid to ensure that no part of the body is found in the
Summary of Contents for Leo Med
