Rehabed Leo Med, Instructions For Use Manual, Page: 33 / 56

33
9. D
ISASSEMBLING THE BED FOR TRANSPORT
▪
Before attempting to disassemble the bed ensure these
instructions have been read and fully understood.
▪
Ensure a risk assessment in line with local health and safety
policy is undertaken to ensure that staff are not put at risk
when performing disassembly activities.
▪
Pay special attention when disassembling the bed - individual
sections of the bed are heavy - see section 15.1 for the weight
of individual parts.
Side rails
▪
Lock all 4 castors.
▪
Raise the side rails to its highest position.
▪
Pull-out the latches (placed at the bottom of the
mounting bushes) and pull the side rail
’ s pivot from
the mounting bushes (to prevent locking the latch).
▪
Repeat for the other side of the side rail.
▪
Carefully remove the side rail by evenly sliding the
side rail
’ s pivots out of the mounting bushes.
▪
Place the side rail on the floor.
▪
Repeat for the other side of the bed.
Electrics
▪
Flatten and lower the bed and the whole mattress platform to its minimum height.
▪
Unplug the mains cable from the mains socket.
▪
With cable ties (or similar), secure the moving parts of the backrest and leg section
to the bed frame.
▪
With cable ties (or similar), secure all cabling and ensure is not dragging on the
floor or is under excess tension.
Bed Ends
▪
Grab the outside tube of the bed end frame, then lift the bed end up.
▪
Carefully set it down on the floor.
▪
Repeat for the remaining bed end.
▪
The bed cannot be transported if any fixing is missing, or any
part of the bed is not fully secured with cable ties or similar -
risk of the bed collapsing.
▪
Make sure that moving parts were secured with cable ties,
stretch foil (etc.)
– the risk of uncontrolled movements of
individual sections during transport.
▪
During transport hold only the constant parts of bed
construction.