Rehabed Leo Med, Instructions For Use Manual, Page: 38 / 56

38
12. M
AINTENANCE
Only authorised service personnel or Reha-Bed sp. z o.o. service engineers should carry
out repairs or service activities. The manufacturer is not liable for unauthorised
repairs. Failure to observe the rule may result in the manufacturer’s warranty
becoming void. Service activities may be performed by any trained person or service
personnel.
The bed must be serviced annually, as a minimum .
The manufacturer also recommends that the care person performs frequent visual and
operational inspections. If there are any signs of damage or the bed is not performing
as it should, it should be withdrawn from service until the bed has been repaired and
is fit for use again.
Periodically check to ensure that:
▪
No parts are missing.
▪
All fixtures and fittings are tight.
▪
No parts show signs of excessive wear (including no cracks near welded areas).
▪
The electrical components display no sign of damage - If so turn off at the mains
and remove the bed from use immediately.
▪
The frame is mechanically operational.
▪
The bed operates as per its intended purpose.
▪
The bed is cleaned following the guidelines in this Instruction Manual.
▪
All accessories and additional equipment are fitted in a right way.
12.1. G
ENERAL
M
AINTENANCE
The manufacturer recommends that the beds are serviced once yearly, as a minimum .
Please act accordingly with the following instructions:
▪
Failure to perform inspections at the recommended frequency
could adversely affect the basic operation of the bed and
(consequently) put the patient at risk.
▪
Always disconnect the bed from the main power supply prior
to performing any maintenance procedures (with the exception
of checking electrical functions of the bed).
▪
Modification of the bed frame is not allowed without the
permission of the manufacturer - A hazard could be introduced.
▪
The bed should be vacated by the patient before any
maintenance or inspection takes place. If this is not possible
due to the patient’s mobility, care should be taken for the
service engineer not to make contact with the patient when
working on electrical items.
▪
Electrical system components are only to be replaced by
authorised service personnel or service engineer.