Regency Plateau® PTO50 Outdoor Gas Fireplace
|
35
35
|
installation
ASSEMBLY INSTRUCTIONS FOR A STEEL STUD
TABLE FRAMING KIT FOR PTO50
919-766
03.13.17
1
OUTDOOR BURNER
Vent Grill Location
Vent Grill Location
Vent Grill Location
Vent Grill Location
ASSEMBLY INSTRUCTIONS FOR A STEEL STUD
TABLE FRAMING KIT FOR THE PTO50 BURNER
Follow these instructions to construct a steel stud table for the PTO50 burner;
Overall dimensions = 24" W x 24" H x 69" L.
**Non-combustible fi nishing board not supplied with kit. Board may be purchased at your local hardware/building supply store.
Note:
For the 100" burner - Four (4) ventilation grills are required for all enclosures when joining two PTO50s together.
This is to alleviate moisture and allow for air to circulate. Minimum recommended size 20"sq (508mm²) ea.
The ventilation grills must be located at the ends of the burner in locations shown above.
KIT CONTENTS:
Top / Bottom
(A) x 2
Vertical Supports - Corner
(B) x 4
Vertical Supports - Inner
(B) x 6
Vertical Supports - Outer
(B) x 4
Wafer Screws
80
Vent (377-060)
2 x Upper
Vent (377-061)
2 x Lower
Tools Required
1 power
drill
+ #2 phillips bit
1 hand
#2 screwdriver
(Phillips)
1 level
1
tape
measure
