20
|
Regency Plateau® PTO50 Outdoor Gas Fireplace
|
20
installation
WALL SWITCH AND BATTERY INSTALLATION FOR TWO UNITS
(INCLUDED WITH UNIT)
919-776
04.10.17
2
OUTDOOR SERIES
PTO80 / PTO100 WALL SWITCH INSTALLATION
(INCLUDED WITH UNIT)
Note: Each unit comes with a wall switch. However, only one wall switch is
required. The 2nd switch can either be discarded or saved as a spare part.
The units come with a low voltage wire and a battery extension wire installed
on each burner.
1. Run supplied wire to desired location - to a max. of 9 feet for both
burners.
2. Install supplied electrical box in desired location.
3. Remove center knock out from electrical box and install strain relief (strain
relief nut not required).
4. Connect both sets of low voltage wires together from each burner - white
with white and black with black.
5. Route low voltage wires and battery extension wire through the strain relief.
Note:
Ensure the battery extension wires are approximately 8" in length inside
the electrical box. This excess will ensure ease of battery replacement
and servicing in the future.
8. Using silicone, completely seal strain relief to protect from water or moisture.
9. Place supplied gasket on top of electrical box.
10. Fasten cover to electrical box using supplied screws.
11. Place switch in OFF position until fi nal installation is complete.
Center knock out
Slide 1st battery
pack to the right.
Strain Relief
6. Attach low voltage wires to the switch - ensure to attach on the right side
of the switch. This will make it easier to remove the 2nd battery terminal
when replacing batteries. Fasten switch to right side of electrical box as
shown below.
7. Install 4- AA batteries into each battery terminal. Ensure correct polarity. Slide
the fi rst battery terminal all the way to the right - until it is next to the switch.
The 2nd battery terminal can be attached to the battery cover with the
supplied velcro.
NOTE:
PTO80 is a PTO50 and PTO30 assembled end to end
PTO100 is two PTO50 units assembled end to end.
