54 | Gi29 Direct Vent Gas Insert
installation
RemoteControlInstallation(optional)
920-482b
08.10.22
1.
1.
Install the receiver with the two provided screws. The tabs to open the battery compartment should be on the top of the receiver when it is
Install the receiver with the two provided screws. The tabs to open the battery compartment should be on the top of the receiver when it is
installed. Feed the wire harness through the receiver mount and route behind the Fan Mount (if the 311-979 fan option has been installed).
installed. Feed the wire harness through the receiver mount and route behind the Fan Mount (if the 311-979 fan option has been installed).
Loop excess wire in provided plastic stick-down clip and attach to firebox bottom, leaving enough slack to pull out the receiver for servicing.
Loop excess wire in provided plastic stick-down clip and attach to firebox bottom, leaving enough slack to pull out the receiver for servicing.
3. Connect the black jumper wire with the red male connector from the
receiver harness to the wire that was connected to "TH".
4.
4.
Connect the green wire on the receiver harness marked "TH" to the
Connect the green wire on the receiver harness marked "TH" to the
top TH terminal on the gas valve.
top TH terminal on the gas valve.
2.
2.
Disconnect the top wire on the TH terminal from the gas valve.
Disconnect the top wire on the TH terminal from the gas valve.
5. Loop the excess wires in the provided clip and stick to bottom of the
5. Loop the excess wires in the provided clip and stick to bottom of the
fireplace, leaving enough extra wire length to allow for servicing.
fireplace, leaving enough extra wire length to allow for servicing.
NO
TE
The remote receiver uses 4 x AA batteries. The remote
The remote receiver uses 4 x AA batteries. The remote
transmitter uses 3 x AAA batteries.
transmitter uses 3 x AAA batteries.
6. Once the remote is installed, follow the coding instructions that accompany the remote control and receiver. See communication between the
6. Once the remote is installed, follow the coding instructions that accompany the remote control and receiver. See communication between the
remote receiver control and the receiver, found in the instruction manual.
remote receiver control and the receiver, found in the instruction manual.
TPTH
To switch
TH
7. Turn the switch located on the lower left side of unit to the ON position to operate the remote control.
7. Turn the switch located on the lower left side of unit to the ON position to operate the remote control.
Receiver
Receiver Mount
1
Gi29 ON/OFF Remote Control (Part # 311-976)
Summary of Contents for Gi29L-LP
Page 76: ...76 Gi29 Direct Vent Gas Insert warranty ...
Page 77: ...Gi29 Direct Vent Gas Insert 77 ...
Page 78: ...78 Gi29 Direct Vent Gas Insert ...
Page 79: ......
