Regency Fireplace Products CF780, Owners & Installation Manual

Page: 28 / 56

CAUTION:
The decorative gas appliance shall be installed in accordance with the Natural Gas Installation Code, CAN/CGA-B149.1-M95. CAUTION: Gas logs shall
be certified for the application. When installed, the chimney damper shall be permanently secured in an open position to effectively vent the appliance. The
log sets need to be certified to ANSI Z21.60/CSA 2.26-2017 to be installed in the fireplace. Do not operate a gas log set in this fireplace with the chimney
removed. Keep door fully open when gas log are used. When burning gas in the fireplace, adjust damper to the fully open position.
Maximum Dimensions of Unvented Log Set:
• Front Width: 32"
• Rear Width: 19"
• Depth: 15"*
Note: When installing gas log set—andirons must be removed and 4 bolts put back into place.
• It is mandatory that the flue damper is set open for use with vented type gas log sets.
• Do not operate an unvented gas log set in this appliance with the chimney removed
• Before installing or operating the gas log set, ensure all refractory bricks and insulation are installed and in good working order.
• This appliance has been tested for use with manufactured gas log sets (max. 56,000 BTUs).
• When vented type log sets are used, the flue damper must be affixed open.
• This appliance has been tested for use with manufactured unvented gas log sets (max. 40,000 BTUs).
tooltip
Drill through panel (either side)
for gas line
tooltip
Gas line opening in unit
1. Determine which side the gas line will enter the unit and remove the gas
opening punch out from the outside of the unit.
2. Slide up the screen door and glass door (instructions in this manual, if
required).
3. Drill through the brick panel on the side chosen to bring in the gas line
using a masonry bit. Drill carefully as brick panels are prone to cracking.
4. Bring the gas line through the unit and install gas log set.
Gas Log Installation
28
|
CF780 Wood Fireplace
installation