55
T R A N S M I S S I O N S
®
Align input shaft spline with damper plate .
Assemble transmission to engine and then install bolts .
Do not use bolts to draw transmission against engine .
Adjust the shift cable so the holes in the shift lever are
centered over the detent ball at each selector location .
See figure 7A .
Read OEM manual for complete installation instructions .
Connect oil line to oil to the cooler outlet . See Figure 7B .
Section II
Installation
Figure 7A. Shift Cable Adjustment
SHIFT LEVER
DETENT BALL
CENTERED IN
HOLE
CAUTION
CAUTION: After a transmission fail-
ure, the cooler should be replaced
and all lines flushed.
WARNING
WARNING: Check the shift lever
at the helm to see that forward
position is also forward position
at the transmission shift lever.
(Transmission should not be run-
ning in reverse when boat is going
forward.)
Temp Sensor Port:
3/8-18 NPSF
thread . Accommodates standard
3/8 NPT thread sensor . Can be
used for mainline pressure port .
Reverse
Forward
Pressure Sensor Ports:
Plug if not using sensors .
(SAE J1926-4 7/16-20 thd .)
Cooler Out Port:
1/2-14 NPSF
thd . Accommodates standard
1/2-14 NPT fitting .
From Cooler Port:
1/2-14 NPT
thd . Accommodates standard
1/2-14 NPT fitting .
Oil Drain Hole:
1/2-14
NPSF thd .
Summary of Contents for Velvet Drive 3007000E01
Page 2: ......
Page 43: ...41 T R A N S M I S S I O N S 72 LVTS...
Page 59: ...57 T R A N S M I S S I O N S Section II Installation...
Page 71: ......