50
T R A N S M I S S I O N S
®
STEP 21.
Install clutch and drive gear assembly in case .
Rotate clutch and drive gear assembly back and forth
to engage ring gear teeth with pinion gear teeth .
STEP 22.
If original case and clutch cylinder are used,
install thrustwasher on face of clutch cylinder .
If new components are used, measure to select proper
thrustwasher .
Position case vertically as shown . Measure from face of
case, without gasket, to face of clutch cylinder .
When dimension is 0 .424 inch (10 .77mm) or less, use
71-15B thrustwasher .
When dimension is greater than 0 .424 inch (10 .77mm),
use 1016-193-001 thrustwasher .
STEP 23.
Install three dowel pins and eleven pressure
plate springs in case .
STEP 24.
Install one steel separator plate in case with
large part of tab to left of dowel pin .
Alternately stack remaining reverse clutch friction plates
and steel separator plates in case (see page 34) .
Section I
Assembly
Clutch and Drive Gear Installation
Thrustwasher Installation
Spring and Dowel Pin Installation
Reverse Clutch Pack Installation
Summary of Contents for Velvet Drive 3007000E01
Page 2: ......
Page 43: ...41 T R A N S M I S S I O N S 72 LVTS...
Page 59: ...57 T R A N S M I S S I O N S Section II Installation...
Page 71: ......