22
T R A N S M I S S I O N S
®
Section V
Overhaul
STEP 29.
Install adapter on case and align bolt holes .
Thread four capscrews into case . Tighten in a criss-cross
pattern to final torque specified in Table 4 .
Lightly tap woodruff key into place in drive gear with a
soft-faced mallet .
NOTE:
Model 3009 uses a round dowel pin in place of
a key .
STEP 30.
Press oil seal into pump body against bore
shoulder .
STEP 31.
Install driven gear in pump body .
NOTE:
Pump gear should be installed the same side
down as removed .
STEP 32.
Lubricate pump gasket with vasoline and
install in groove of adapter .
Install pump drive gear onto input shaft . Check that
pump drive gear locates freely on woodruff key and
shaft .
Adapter Installation
Oil Seal Installation
Pump Driven Gear Assembly
Pump Gasket Installation
CAUTION
CAUTION: Oil Seal must be
installed dry. Lubricants can
damage rubber coating.
Summary of Contents for Velvet Drive 3007000E01
Page 2: ......
Page 43: ...41 T R A N S M I S S I O N S 72 LVTS...
Page 59: ...57 T R A N S M I S S I O N S Section II Installation...
Page 71: ......