23
T R A N S M I S S I O N S
®
STEP 33.
Install pump assembly on top of adapter and
align bolt holes . Apply thread locker to bolts - apply
Loctite 242 or equivalent .
Thread four bolts into adapter . Tighten in a criss-cross
pattern to final torque specified in Table 4 .
STEP 34.
Assemble pressure relief valve assembly .
Refer to figure below .
Lubricate O-rings with vasoline and install on end of
valve assembly .
NOTE:
Gap in snap ring must be aligned with notch in
control valve .
STEP 35.
Slide valve assembly into side of case .
STEP 36.
Install valve cover as follows:
Position gasket on case . Place valve cover over gasket
and align bolt holes .
Thread three bolts into case . Tighten bolts in a criss-
cross pattern to final torque specified in Table 4 . Apply
thread sealant to bolts . (Loctite 242 or equivalent)
STEP 37.
Install shift lever as follows (manual shift only):
Insert shift spool into housing . Lubricate o-ring before
installation . Insert snap ring into housing to retain
spool .
Lubricate poppet spring and hole in case with grease .
Place poppet spring and steel ball in case .
Slide shift lever over end of control valve assembly and
against steel ball . Rotate shift lever to engage steel ball
in hole of shift lever .
Hold shift lever against steel ball . Install washers and
thread nut on shifter spool assembly . Tighten nut to
torque specified in Table 4 .
STEP 37A.
Electric Shift
Be sure cartridge screen is clean. Insert cartridge into
port and torque to spec in Table 4.
Slide coils over cartridge stem. Be sure you have the
spacer washer between the 2 coils. Position coils as
needed and tighten nut to spec in Table 4.
Section V
Overhaul
Pump Assembly Installation
Shift Lever Assembly
NUT
LOCK WASHER
FLAT WASHER
STEEL BALL
SPRING
SHIFT LEVER
DIPSTICK
CONTROL VALVE
PRV Valve Assembly
CONTROL VALVE
VALVE SLEEVE
SPRING
SPRING RETAINER
SNAP RING
CAUTION
CAUTION: Position pump housing
with cast arrow at top pointing
in the same direction as engine
rotation.
Summary of Contents for Velvet Drive 3007000E01
Page 2: ......
Page 43: ...41 T R A N S M I S S I O N S 72 LVTS...
Page 59: ...57 T R A N S M I S S I O N S Section II Installation...
Page 71: ......