19
Periodical Maintenance
Cleaning the Filter
It is recommended that the filter is periodically
cleaned in order to maintain the performance
of the shower. It is essential that this operation
is carried out by a competent person.
The inlet filter is situated inside the water inlet
fitting (See Diagram 26).
To gain access to the filter remove the cover
and right hand trim plate. When removing the
cover be careful that you
DO NOT
tug the
flying lead from the PCB which is attached to
the cover. Disconnect the flying lead from
the reverse of the front cover.
Holding the filter body with a spanner across
the flats, unscrew the top cap on the water
inlet fitting using another spanner.
Inspect the ‘O’ rings on the filter body for any
damage when removed from the inlet assembly.
When cleaning the filter,
DO NOT
use a sharp
object, as it will cause damage. It is preferable
to use an old toothbrush or similar
Do not remove the filter mesh from the body
and clean whilst still in position.
Refit the filter making sure it is screwed fully
home. Do not over tighten the filter cap on
reassembly.
WARNING!
Switch OFF the electricity at
the isolating switch and the water supply
at the mains before removing the cover.
Diagram 26
Troubleshooting
If the performance of the shower deteriorates in service, follow the checks in the “Self Help” table
below before calling out the contractor.
Any one of the simple adjustments could restore the performance.
If these fail to restore the performance you should seek professional help.
The person who installed the shower is probably the best one to repair it and is certainly the person
to contact if you have a problem in the guarantee period.
I
I
SELF HELP CHECK LIST
a) Water too HOT
b) Water too COLD
c) Spray pattern poor
I
I
Press the cooler button.
Clean spray plate holes on showerhead.
Press the warmer button (See Page 9 For allowed
adjustment range) .
Clean spray plate. Select Outer/Inner only.
I
I
