How To Use Your Shower
Warmer
Cooler
Start/Stop
Temperature
Temperature
Lock
Selectronic
Premier
Temperature
Lock Light
Warmer
Cooler
Start / Stop
To Switch The Shower On :
Switch On Electricity
at ceiling / isolating switch.
Press the Start / Stop button
. (Confirmed with a
single bleep
). (See Diagram 13).
The shower will start and display the target running temperature for about two
seconds. An internal motor will also adjust to give the optimal flow rate.
Note
The
target
start up
temperature
is set by the installer. (See Installer section).
This is
normally 40°C (Digit 5)
, with
adjustment
being
34°C to 40°C (Digit 1 to 5)
.
After two seconds the Display will change to show the actual temperature (usually “L”).
The digit will flash and increase until the Display reaches the target running temp.
When the shower has reached the target temperature it stops flashing.
A
double bleep
will
sound
, indicating the shower is
ready to use
.
(The shower will only double bleep once per shower session).
To Change The Shower Temperature :
Press
the
Warmer Button
to increase
the temperature. (See Diagram 14).
(Confirmation with a
Single Bleep).
Audible Short
Bleep
1
Diagram 13
12
Diagram 14
Audible Short
Bleep
1