RDL-3000
INSTALLATION GUIDELINES
70-00159-01-06
Proprietary Redline Communications © 2012
Page
53
of 65
kune 12, 2012
5.5.5
Step 5: Create and Enable a Wireless Link
Using the Provisioning menu, the operator must configure at least one Link, Service, and
Service Group before the sector controller can establish a wireless link, measure signal
strength (e.g., RSSI and SINADR), and pass Ethernet traffic. All provisioning settings are
made on the sector controller (PMP SC).
Figure 43: Procedures - RDL-3000 Basic Pass-Through Configuration
Use the following steps to set up a 'Pass through' configuration (no VLAN support) and
have the RDL-3000 system transparently pass all Ethernet traffic. The steps must be
performed in the order they are listed.
Add a Subscriber Link
Create a Subscriber Link named 'Link-1' and configure the wireless link.
1.
Click Provisioning->New Subscriber Link in the main menu.
2.
Enter data for the following fields:
3.
Link Name: Link-1
4.
Peer MAC
: [Subscriber MAC address]
5.
Use defaults for all other fields.
6.
Click
Apply
to activate these settings.
7.
Click
Save All
in the main menu to save changes to the provisioning configuration.
Repeat these steps to add additional links if required.
Add a Service Group
Create a Service Group named 'Group-1' to forward all Ethernet traffic received on the
sector controller Ethernet port.
1.
Click
Configuration->Service Group
in the web page main menu.
2.
Click the
Add New
button and enter data for the following fields:
3.
Name
: Group-1
4.
Tagging mode
: Pass-through
5.
SC Ethernet Enable
: Click to check the box
.
6.
Use defaults for all other fields.
7.
Click
Apply
to activate this Service Group.
8.
Click
Save All
in the main menu to save changes to the provisioning configuration.
