RED LOGIKA 25, Installation Manual

Page: 49 / 80

47
g
p
s
f
T
A
B
47
6 - INSTALLATION AND ASSEMBLY OF BOILER
Technical Dept. - All rights reserved - Reproduction is prohibited
f) assembly of the smoke pipe and lambda probe
Take the packages containing the pipe and lambda probe out of the firebox holder in the boiler. Assemble the probe on the probe as
follows:
• slide the plastic hood “ p ” off the probe “ s ”.
• screw the probe “ s ” onto the thread “ f ” on the pipe “ T ”.
• Check that the gasket “ g ” is on the intake of pipe “ T ”. If this is not present, you need to request it. Pipe “T” should not be assembled
without the gasket.
ATTENTION! Fasten on the lambda probe with care.
Next, insert the probe pipe on the smoke outlet pipe of the boiler as shown in the figure.
T = Pipe diameter 100
f = pipe thread
p = plastic cap
s = probe
g = gasket
A = PROBE PIPE
B = SMOKE OUTLET PIPE