13. The camera restarts and displays the
Initializing...
message.
14. The camera displays the
Two-Stage Firmware Upgrade
progress screen.
15. The camera displays the
Shutting Down...
message and reboots again.
16. The new
Initializing
progress screen displays.
17. The
Firmware Upgrade
progress screen displays.
18. The
Firmware Upgrade
success message screen displays with a
Restart
button.
19. Tap the
Restart
button. The Shutting Down message displays.
20. The camera restarts displaying the BETA warning, and then the new
Initializing
progress screen displays.
21. When this is your first time upgrading the firmware, a pop-up menu opens with the Software License Agreement
(SLA). Select
Agree
. If you do not agree to the SLA, the camera cannot be used. The SLA continues to display
until it is accepted.
22. Verify that the firmware version listed matches the firmware version that you downloaded.
23. Reformat the CFast media card before recording.
SYSTEM MAINTENANCE
All RED products are designed for rugged durability, but precision instruments demand proper care. Follow the
instructions in this section to clean, maintain, and store your devices.
WARNING:
DO NOT rinse or immerse the camera or other accessories in water. Keep dry at all times.
WARNING:
DO NOT use soaps, detergents, ammonia, acetone, alkaline cleaners, abrasive cleaning compounds, or
solvents. These substances may damage lens coatings and electronic circuitry.
WARNING:
DO NOT use an excess of cleaning solution.
WARNING:
DO NOT reuse swabs or wipes.
WARNING:
DO NOT attempt to clean the sensor or optical cavity for any reason. If the sensor becomes dirty, submit
a Support ticket at
https://support.red.com
.
WARNING:
DO NOT attempt to modify, dismantle, or open the camera, lens, or other accessory as doing so may
expose you to electric shock and serious injury. There are no user-serviceable parts inside. Alteration or repairs made
to the camera or accessories, except by a RED authorized service facility, voids all warranties.
WARNING:
Use caution with compressed air and gas dusters, since the high pressure, oily residue, cold air,
particulates, and moisture may cause damage. You may use a filtered, non-residue gas duster to clean non-critical
areas, such as around the fans and other recesses on the exterior of the camera. Damage to the camera or other
components of the camera system caused by using compressed air or gas dusters is not covered under warranty.
WARNING:
DO NOT use compressed air and gas dusters on the sensor or on any optics.
WARNING:
DO NOT use compressed air and gas dusters on or around the integrated microphones on the front of the
camera.
COPYR IGHT © 2 0 2 0 R E D.COM , LLC
9 5 5 -0 1 9 0 , R E V -B E TA 1 .0 | 1 4 3
KOMODO OPERATION GUIDE
BETA
