INSTALL BACKPACK BASE PLATE AND BACKPACK QUICKPLATE
(SHORT)
REQUIRED TOOL(S):
3.0 mm Hex driver
1. Turn off the camera.
2. Place the Backpack Base Plate on the rear of the BRAIN.
3. Insert four (4) M4x0.7 mm x 8 mm mounting screws into the Backpack Base Plate mounting holes.
4. Use a 3.0 mm Hex driver to tighten screws in a cross pattern (“X” pattern) approximately two (2) turns each.
DO NOT FULLY TIGHTEN.
5. Fully tighten the four (4) screws in a cross pattern (“X” pattern).
WARNING:
DO NOT OVERTIGHTEN.
6. Loosen the wingnut clamp on the Backpack Base Plate.
7. Slide the Backpack Quickplate (Short), with the V-Mount receiver facing away from the BRAIN, into the dovetail
rails on the Backpack Base Plate.
8. Tighten the wingnut clamp on the Backpack Base Plate.
WARNING:
DO NOT OVERTIGHTEN.
9. Connect the 6-pin 1B LEMO connector to the
DC IN
port on the BRAIN.
Figure: Backpack Quickplate (Short) Collection with a RED BRICK
NOTE:
The release button is black on the Backpack Quickplate and red on the Backpack Quickplate (Short).
INSERT A BATTERY
1. Slide the RED BRICK or REDVOLT-V onto the back of the Backpack Quickplate so that it fits into the V-Mount on
the back of the Backpack Quickplate.
2. Apply pressure until the battery is fully seated.
NOTE:
You may not hear a click when the battery is fully connected.
REMOVE A BATTERY
1. Press the release button on the side of the Backpack Quickplate to remove the RED BRICK or REDVOLT-V.
2. Pull up on the battery to disengage it from the V-mount.
C O PYR I G HT © 2 0 1 7 R ED.C O M , LLC
9 5 5 - 0 0 3 8 , R EV - AD
|
4 6
RED DSMC POWER OPERATION GUIDE