15
IN
ST
A
LL
AT
IO
N
IN
ST
A
LL
A
ZI
O
N
E
Consensi
Alimentazione
Morsetti in tensione
Morsetti privi
di tensione
Fase
Neutr
o
Terr
a
Ner
o-
M
AX
v
el
.
Bl
u-
M
ED
v
el
.
Rosso
- M
IN
v
el
.
Velocità ventilator
e
Co
ns
en
so
deumidific
ator
e
Fo
rzatur
a
ventilator
e
Utilizzare la macchina con portate maggiori alla
nominale non comporta alcun vizio funzionale
ma cambiano le condizioni dell’aria in uscita
rispetto a quelle dichiarate.
Non scendere a portate inferiori a 200 mc/h d’aria
in quanto la macchina potrebbe lavorare a temperature
troppo elevate.
FORZATURA DELL’UNITÀ IN SOLA VENTILAZIONE
Sono disponibili sulla scheda elettronica di controllo
del deumidificatore due morsetti che permettono di far
funzionare l’unità nella modalità di sola ventilazione.
La chiusura del “consenso ventilazione” attiva il ventilatore.
Le indicazioni sui principali collegamenti elettrici che
devono essere effettuati da parte dell’installatore sono
riportati sul dorso del coperchio del quadro elettrico.
CONSENSO ESTERNO (DEUMIDIFICAZIONE)
L’unità potrà essere avviata solo se saranno stati effettuati
correttamente i collegamenti del consenso remoto (ad es.
umidostato, controllo remoto a microprocessore, ecc.).
A tale riguardo attenersi scrupolosamente a quanto riportato
nello schema elettrico. Nel caso non fosse disponibile alcun
consenso remoto ponticellare i relativi morsetti.
I morsetti del consenso remoto vengono ponticellati in
fabbrica ed etichettati con la scritta UMIDOSTATO: se si
dispone di un dispositivo di consenso remoto rimuovere
tale ponte e procedere al suo collegamento secondo
quanto indicato nello schema.
Consent
Electrical power supply
Terminals with tension
Terminal without
tension
Phase
Neutr
al
Ea
rt
h
Black - MAX spped
Blue - MED speed
Red - MIN speed
Fan speed
External consent dehumidific
ation
Fo
rcing
ventilation
�sing the machine with flow rates which exceed the
rated flow rate does not lead to any operating defect
but the outlet air conditions change compared to
the declared ones.
Do not use air flow rates lower than 200 m³/h as the
machine could work at temperatures which are too high.
FORCING THE UNIT IN VENTILATION MODE ONLY
Two terminals are available on the dehumidifier circuit board
which allow the unit to be operated in ventilation mode only.
The closure of the “ventilation consent” activates the fan.
Information about the main electrical connections which
must be made by the installer is shown on the back of the
electrical panel cover.
EXTERNAL CONSENT (DEHUMIDIFICATION)
The unit may only be started up if the remote consent
connections (e.g. humidistat, remote microprocessor control
etc.) have been made correctly.
On this topic, follow the information shown on the wiring
diagram very carefully. If no remote consent is available, jumper
the relative terminals.
The remote consent terminals are jumpered in the factory
and labelled with the wording HUMIDISTAT: if a remote
consent device is available, remove this jumper and
connect it as shown on the diagram.
Summary of Contents for RNW 400 CS
Page 2: ......
Page 28: ...cod 9100072 03 10 2011...