DOCUMENTATION RESERVED FOR RCH SERVICE CENTERS.
RCH TOUCH ME
- -
5
1. INTRODUCTION
This manual contains information and basic procedures for the installation and
maintenance of the TOUCH ME cash register; it must be used together with the
programming and user’s manual.
1.1 TECHNICAL CHARACTERISTICS
Power Supply: DC 12V MAX 3A Operating temperature: 0 to +50 °C
Thermal Printer: ELM 208 Thermal Paper Rolls: 1 x 57.5 mm max diameter 50 mm
E.J.: MMC
Connection of the TOUCH ME cash register to the power grid is done by means of an
easily accessible electric outlet, located near the device and equipped with grounding. The
device must not be exposed to rain or humidity.
This device is compliant to European directives EMC 89/336/EEC and LVD 73/23/EEC
(EC marking). In order to guarantee compliance to safety and electromagnetic
compatibility norms, use original spare parts only. In case of the power supply should fail,
replace it entirely. Respect original positioning of all cables.
The builder is not responsible for any damage the product may cause in case of:
improper use, non-compliant installation with norms in force, technical assistance that is
not authorized or that does not respect instructions supplied, the use of non original spare
parts, or the removal of parts that are fundamental for safely using the device.
1.2 OPERATION
The TOUCH ME cash register has been specifically studied for the markets for the
emission of receipts on thermal paper and the storage of the journal on E.J. (Electronic
Journal: MMC support).
The cash register must only use homologated specific thermal paper rolls in order to
guarantee the permanence of registered date on paper.
Norms on cash registers give the following indications for the use and storage of rolls and
daily reports:
•
Daily report rolls and receipts must be stored in appropriate areas: temperature
must not exceed 35°C, humidity must not exceed 80%.
•
Rolls and receipts must not come into contact with PVC; this avoids the risk of
erasing the writings.
Thermal paper rolls for cash registers must be used before the expiration date written on
the roll itself.
CHECK BEFORE INSTALLATION
-
That the feeder cable is easily accessible by the user, and therefore located close to
the device. If necessary, it must be possible to easily find the electrical outlet so that
the plug can be removed if necessary.
-
That the serial number printed on the cash register corresponds to the one indicated on
the serial plate.
