RCH
INSTALLATION AND MAINTENANCE MANUAL model TOUCH ME
- 42 -
o
Wait a few seconds and then enter the correct DATE and TIME, pressing the
[CASH] key to confirm each value. If the display reads out
FORWARD DATE
after you have entered the new time and date, check the date you have
entered because it is three days later than the date when the last cash
balance was made.
o
The cash register now prints out a report (not a tax receipt) confirming that
the new firmware is functioning and then returns to Register mode (REG).
o
Check that the paper roll is in place, correctly aligned and fed.
o
Proceed as follows to check that the firmware update as been completed
correctly:
5
–
KEY
-
555
–
CASH
-
-%
(twice) -
CASH
(The new FW version is displayed.)
o
Switch off the cash register. Unplug the serial connection cable. Replace the
top cover and secure it with the screws and seal (see section 6.2).
o
Check that the paper roll is still in the right position and proceed to program
the cash register.
NOTE: If the cash register has already been configured for tax,
the receipt header is already in memory and need not be re-
programmed. Do not re-program the receipt header if there is no
need, to avoid filling the limited memory space available for tax
data.
