RBCBioscience MagCore HF16 Plus, Training Manual

Page: 54 / 96

53
3
2
5
4
Replace the C-axis motor
Open the back service lid.
1. Unplug the connector wires of the C-axis motor.
2. Screw off the four screws of the optic lamp driver (3mm Hex wrench).
3. Screw off the two screws of the driven timing gear (4mm Hex wrench).
4. Screw off the four screws of the motor (3mm Hex wrench).
5. Screw off the two set screws of the timing gear (1.5mm Hex wrench).
6. Replace a new C-axis motor.
7. Install the new C-axis motor orderly on the machine.
8. Note that the belt should be a little tight after installation.
1
1