Raytools XC3000S Series, Commissioning Manual, Page: 121 / 138

XC3000S Series Laser Cutting
S
y
stem Commissioning Manual
92
Safety door alarm stop
processing Unchecked When checked, processing will be stopped when the
safety gate alarm is activated during processing
Laser brand IPG Just choose by the actual laser brand
Laser power 1000 Average power of the filled laser
Frequency 5000 Fill in the laser frequency, commonly 5000Hz
Voltage of max power 10 Fill in the maximum value of the laser feedback power
analog, commonly 5V and 10V
Feedback voltage of max
power 10 Fill in the maximum value of the laser feedback power
analog, common 5V and 10V
Output delay 0 are filled in advance.
Analog output delay 0 The analog output is filled in advance and then output
enable signal and PWM signal, generally for 50ms
FlyCut laser on delay 0 How many ms in advance of the flying cut? This
parameter is usually filled in 0, and it is recommended
to use the advance distance in the nesting to adjust
whether the flying cut contour is closed or not.
FlyCut laser off delay 0 How many ms of flying cut lag to turn off the light? This
parameter is usually filled in 0, and it is recommended to
use the advance distance in the nesting to adjust
whether the flying cutting contour is closed or not.
7.6.8 Assist gas cell valve and analog output settings